Audi A8 2010, Руководство по обслуживанию

Страница: 56 / 142

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Use your hands to check that all underbody trim panels and
wheel housing liners are secured correctly and check for miss‐
ing fasteners.
– Inspect side members for deformations.
– Check visible area of pipes/wiring and connections for dam‐
age and ensure they are secured correctly.
– If faults are found: Renew missing fastener or damaged com‐
ponent.
3.23 Roof insert: checking operation
WARNING
Risk of injury as engine of high-voltage vehicle can start un‐
expectedly!
♦ Observe warnings for high-voltage system:
♦ For work that must be performed with the ignition switched
on ⇒ page 11 .
Only applies to equipment version with sliding/tilting sunroof.
Cleaning and lubricating the roof insert is a repair measure and
should be charged separately.
Procedure:
– Open and close roof system completely and check for unusual
noises and stiffness/sticking.
– If there is unusual noise or stiffness/sticking: Clean and lubri‐
cate roof insert ⇒ page 52 .
3.24 Roof insert - sliding/tilting sunroof:
cleaning and lubricating
WARNING
Risk of injury as engine of high-voltage vehicle can start un‐
expectedly!
♦ Observe warnings for high-voltage system:
♦ For work that must be performed with the ignition switched
on ⇒ page 11 .
Special tools and workshop equipment required
♦ Lubricating paste - G 060 751 A2-
♦ Krytox lubricating paste - G 052 141 A2-
♦ Cleaning solution - D 009 401 04-
♦ Industrial vacuum cleaner, e.g. wet/dry vacuum cleaner - VAS
5128-
♦ Commercially available paintbrush: approx. 15 mm wide and
bent by approx. 40° using workshop equipment
♦ Fine-pored sponge (e.g. a piece of household sponge without
a scouring surface)
Audi A8 2010 ➤
Maintenance - Edition 11.2014
52
3. Maintenance