Fig. 484: Marking Line End Of Air Line In Vehicle And Both Ends Of New Air Line
Courtesy of VOLKSWAGEN UNITED STATES, INC.
Then mark line end of air line in vehicle and both ends of new air line using a waterproof marker.
With markings 17 mm or 22 mm, check whether air line is inserted far enough into connecting piece.
Attach sponge rubber onto both lines.
Install new connection.
Remove protective transportation cap.
front suspension strut (air spring suspension) and solenoid valve block is
replaced completely by original equipment line.
Air line between solenoid valve block and left front suspension strut (air
spring suspension) can be replaced with parts from repair kit in left and
right wheel housings.
In vehicle interior, damaged air lines are replaced completely with original
equipment lines. Route new air line along on air line/wiring harness.
Secure new air line at points marked. Replace cut cable ties if necessary.
Clean area of separating point before disconnecting an air line connection.
Dirt penetrating into the lines can lead to a malfunction or system failure.
Clean areas of connecting piece and corresponding separating points.
Remove connecting piece and remove air line.
NOTE:
Connecting pieces in connection are already threaded to tightening
torque. Air lines must only be inserted.
2008 Audi A6 Quattro
SUSPENSION Suspension, Wheels, Steering
FIXYOURCAR
1:42:01 AM
Page 29
