MAINTENANCE TOOLS
Output Signal Simulation
The output signal simulation simulates output signalling to confirm that outputs and associated control circuits are operating
correctly.
NOTE
To test operation of the flags (motor temperature and low/high current), set an output relay to the appropriate function
and monitor the relay's behaviour.
To use the output signal simulation:
1.
Press ALT then TOOLS to open the Tools.
2.
Scroll to Output Signalling Simulation and press .
3.
Use the
and
buttons to select a function to simulate, then press .
4.
Use the
and
buttons to turn the signal on and off.
To confirm correct operation, monitor the state of the output.
Prog Relay A
Off
On
5.
Press to return to the simulation list.
Analog Output Simulation
The analog output simulation uses the
and
buttons to change the current at the
analog output terminals.
Analog Output A
0%
4.0mA
Attach a current measuring device to the analog output terminals. Use the
or
button to adjust the percentage value on the
display. The current measuring device should indicate the same level of current as shown on the display.
If the input/output expansion card is fitted, the simulation can also be used to test the operation of Relays D, E, F and Analog Output B.
Temperature Sensors State
This screen shows the state of the motor thermistors and RTD/PT100s.
S = Short
H = Hot
C = Cold
O = Open
Temp Sensors State
Thermistor: 0
RTD/PT100s:OOOOOOO
S = Shrt H=Hot C=Cld O=Opn
RTD/PT100s B ~ G are only available if the RTD/PT100 and Ground Fault expansion card is fitted.
Digital I/O State
This screen shows the current status of the digital inputs and outputs.
Digital I/O State
Inputs: 0110000
Outputs: 0000100
The top line of the screen shows the start, stop, reset and programmable inputs (A and B, then inputs on the I/O expansion card (if
fitted).
The bottom line of the screen shows programmable output A, the fixed Run output, programmable outputs B and C, then the outputs
on the expansion card (if fitted).
Analog I/O State
This screen shows the current status of the Analog I/O
Analog I/O State
Input: - - - - %
Output A: 04.0mA
This screen will also show Analog Output B if the expansion card is fitted.
28
| User Manual (710-04840-00M)
Содержание EMX3-0023B
Страница 1: ...EMX3 Soft Starter USER MANUAL ...
