ATTO Technology FibreBridge 4500C, Инструкция по установке и эксплуатации

Страница: 35 / 65

28
M
a
in
tenance com
m
an
ds
CLI Error Messages
The following error messages may be returned by the Command line Interface:
ERROR. Invalid Command. Type ’Help’ for command list.
ERROR. Wrong/Missing Parameters
Usage: <usage string>
ERROR. Command Not Processed.
SpeedWrite
SpeedWrite is a method to improve the performance of FCP WRITE commands to SCSI devices attached to the FibreBridge. You can specify the
SCSI bus, target and LUN of a mapped device or specify “all” to set or get the state of all currently mapped SCSI devices.
Limits: enabled, disabled
Actions: set SpeedWrite [sb st sl |all] [enabled
|disabled]
Information: get SpeedWrite [sb st sl |all]
SaveConfiguration
SpeedWriteDefault
Specifies the state of SpeedWrite for any SCSI devices mapped manually or via an AutoMap operation. If enabled, any new SCSI device will use
SpeedWrite performance enhancement by default.
Limits: enabled, disabled
Actions: set SpeedWriteDefault [enabled |disabled] Information: get SpeedWriteDefault
SaveConfiguration
Zmodem
Allows transfer of a firmware image to or from the FibreBridge using the ZMODEM file transfer protocol.
Limits: available only through the RS232 interface
WARNING After a firmware image is downloaded to the FibreBridge, the image is placed into flash memory. During
this time (about 30 seconds), DO NOT remove power to the FibreBridge or the flash may become corrupted.
Actions: Zmodem [Send filename | Receive] Information: none
Returns: Z MODEM transfer complete on success
ERROR with status message on failure