6
Maintenance and care of the sys-
tem
Before maintenance, do all prepara-
tion work so there is no danger to life or
limb or object damage during mainte-
nance and repair work.
Value is placed on long lifetimes and safety in the
development and production of Nußbaum prod-
ucts. To guarantee the safety of the operator, prod-
uct reliability, low running costs, keep the warranty
and also the long-lifetime of the product, proper
set up and operation is just as important as regular
maintenance and !ufficient care.
Our platform! fulfil or
e’ceed
all !afety !tandard! of
the countries we supply to. For example, European
regulation! require a !ervice by qualified
e’pert!
every 12 months of work of the platform. To guaran-
tee the largest possible availability and functional
capacity of the lift system, ensure the list of any
cleaning, care and maintenance work is done.
The lift system is to be serviced at regular intervals
according to the following plan. For intensive oper-
ation and higher degree of contamination shorten
the service interval.
The complete function of the lift system is to be ob-
served during daily use. Customer service must be
informed of any malfunctions or leaks.
To simplify maintenance work, follow instructions on
the maintenance sticker that is found somewhere
on the unit, depending on the lift design.
6.1
System maintenance plan
Before beginning service, disconnect
from power. The system is to be se-
cured against unintentional lowering
and unauthorized access.
6.1.1 As required or visible damage
)
Check the polymer overlays and replace if re-
quired.
6.1.2 Maintenance 1 x per year
)
Check condition of the model plate, load capac-
ity and sticker. Exchange them if damaged or il-
legible.
)
Free the piston rod of the lifting cylinder of sand
and dirt.
)
Check the wiper for damage.
)
Moving parts such as joint bolts and DU bearings,
sliding pieces, sliding surfaces and rollers are to
be cleaned and checked for wear, exchange if
required.
)
Lubricate all lubrication nipples with an acid-free
multi-purpose grease. Do not over-lubricate.
)
All weld seams must have a visual inspection. Stop
the system and contact the manufacturer if there
are cracks or breaks in weld seams.
)
Check the powder coating and improve if re-
quired.
Damage by
e’ternal
influence! i! to be treated
immediately after detection. If these points are
not treated, infiltration of depo!it! of all kind! can
cause wide-ranging and permanent damage.
The!e point! are to be lightly !anded (120 grit),
cleaned and degreased. Afterwards, rework with
a !uitable touch up paint (note the RAL No.).
)
Check the condition and function of the driving
ramp.
AD H9402
19.05.2015
JUMBO LIFT 3200 NT - HYMAX XX 3200 PH
59
