)
Inspect the hazardous area.
No person or object may stand in the working
area of the lift, or on the lift.
)
S;itch on control!. Turn the main !;itch (1) to po-
!ition "1" (!ee figure 003).
)
Lift the vehicle. Push the
o
"Lift" (2) button.
)
If the wheels are not blocked, interrupt the lifting
process and check for proper seating of the poly-
mer overlays.
)
Raise the vehicle to the desired working height.
Push the
o
"Lift" (2) button.
5.3
Lowering the vehicle
)
Inspect the hazardous area.
No person or object may stand in the working
area of the lift, or on the lift.
!
The vehicles cannot be lowered into the lowest
position without wheels. Otherwise the lift can-
not raise the load using its own force. The ve-
hicle could be damaged.
)
Lower the vehicle to the desired working height or
completely lower it. Push the
u
"Lo;er" (3) button
(!ee figure 003).
)
The entire lowering process must be observed.
)
If the lift is in the detectable lowest position, re-
move the polymer overlays and drive the vehicle
from the lift.
5.4
Balance the drive rails
See "Section ".3 filling and venting the hydraulic !y!-
tem".
58
JUMBO LIFT 3200 NT - HYMAX XX 3200 PH
19.05.2015
AD H9402
