32
139435_A GZ
455
DV 8/28/12
8.5 Battery Replacement
Battery life depends on many variables; the quality of
the batteries, frequency of remote use, and mode of
pilot operation. Keep a supply of good quality batteries
on hand to be assured of functional continuity in the
event of a power failure.
The Remote Transmitter batteries are easily accessed
through the tabbed cover plate. Be sure to orient the
batteries for correct polarity as indicated in the battery
compartment.
8.5.1 Receiver Battery Replacement
It will be necessary to remove the left side compartment
door to access the battery cover plate.
1. Remove the lower door hinge bracket ( one, 10 mm
nut). The door will drop out of the upper hinge
bracket.
2. Push the slider switch into the OFF position. Remove
the Receiver cover plate screws and pry the cover
plate with slider switch off of the battery box. See fig.
8.3..
3. Install 4 AA batteries into the receiver bay. Note the
polarity of the batteries and insert into the battery
bay as indicated on the bay cover (+/-).
4. With the switch still in the OFF position, align the
slider switch with the switch stem and snap the cover
plate back onto the battery box.
5. Replace the Receiver cover plate screws.
6. Replace the Compartment Door and lower hinge
bracket.
8.6 Accent Lamp Replacement
Handle the replacement bulb with gloves. Skin oils will
cause the bulb to fail prematurely. If you touch the bulb
with your bare fingers, wipe it clean with a soft cloth.
1. Remove lamp compartment cover plate. See fig.8.4.
.
2. Remove the two phillips screws from the bulb socket
to access the bulb. Pull the bulb out of the housing.
3. Plug the new bulb into the socket and re-install the
cover plate into the lamp housing
.
8.5.2 Initializing the Remote Control
Each time you replace the batteries, you may need to
initialize communication between the Receiver and the
Transmitter.
1. Place the slider switch in the REMOTE position.
2. Insert the end of a paper clip into the hole marked PRG
on the Receiver cover. The Receiver will “beep” three (3)
times to indicate that it is ready to synchronize with
the Transmitter.
Figure 8.4. Remove cover plate to access lamp bulb.
Use 222943 Bulb, 130V / 50W
Lamp Coverplate
Figure 8.3
Receiver battery access.
5. Beginning at the midpoint of the lower edge, apply
the new gasket around the glass panel, with the adhe-
sive side inside and the thicker portion on the outside.
DO NOT STRETCH THE GASKET MATERIAL. Trim off any
excess, leaving a 1/2” overlap as shown in fig. 8.1.
6. Lay the glass panel within the glass frame and press
the tabs back down or press the clips in place as
shown in fig. 8.2
3. Install 3, AAA batteries in the Transmitter bay and
push the ON button. The Receiver will “beep” four
times to indicate the Transmitter’s command is
accepted and sets to the particular code of that
Transmitter. The system is now initialized.
