Atomic G05214W, Инструкция по эксплуатации

Страница: 6 / 17

6 © 2013 Escalade Sports For Customer Service Call 1-886-996-2729
All Right Reserved.
PARTS REQUIRED
8 pcs - H5 Flat Washer 8 pcs - H16 Phillips Round Head Screw 2 pcs - P19L Large
8 pcs - H6 Hex Head Bolt 4 pcs - H18 Phillips Washer Head Screw Cue Clip
8 pcs - H7 Barrel Nut 2 pcs - P19S Small Cue Clip 1 pc - T1 Wrench
STEP 3:
With the help of another adult, attach the assembly from STEP 2 (FIGURE 2) to the assembly from STEP 1 (FIGURE 1B)
using H6 Hex Bolts with H5 Flat Washers and H7 Barrel Nuts as shown in FIGURE 3 . Do Not Tighten H6 Bolts at this
time. Next, secure P15 Leg Panel Stiffener using H18 Screws as shown in FIGURE 3 . Use T1 Wrench to tighten H6 Bolts.
Attach P19S Small & P19L Large Cue Clips to P15 Leg Panel Stiffeners using pre-drilled holes with H16 Screws as shown
in
FIGURE 3
.
Important Note: Be careful not to strip these screws. All H16 & H18 Screws must be tight - but not
stripped.
H5
H6
H18
H6 H5
H18
H7
H16
P15
P14
FIGURE 3
Assembly from
STEP 1 .
Assembly from
STEP 2 .
P19L
(Large)
P19S
(Small)
P19S
(Small)
P19L
(Large)
FIGURE 4
STEP 4:
Thread H14 Leg Levelers onto each P3 Right Leg and
P4
Left Leg as shown in
FIGURE 4
.
PARTS REQUIRED
4 pcs - H14 Leg Leveler
P3
H14
P4
H14
P4
H14
H14
P3
IMPORTANT NOTE:
Tighten, But do not overtighten all
H6
Bolts.
IMPORTANT NOTE:
Install each P14/P15 (Assembly from STEP 2) by making sure the 5(five)
black barrel nuts are facing inside of table.