AT-OME-MS42
73
Solution Setup and Configuration Guide
9.
Scroll down to the bottom of the page and locate the
RS-232 / IP commands
section.
10. Click the
Manufacturer
drop-down list and select the manufacturer of the device that is being controlled. In the
example below,
Samsung
is selected.
NOTE:
If the manufacturer is not listed in the drop-down list, then select
Generic
. When Generic is
selected, the
Products
and
Model
drop-down lists will only list
Generic
.
11.
Continue fine-tuning the device selection by clicking the
Products
and
Model
drop-down lists. Once all fields
have been set to the proper values, the AT-OME-MS42 will populate the command fields with the proper values,
based on the selected device.
12.
Some devices may require that the command be sent multiple times before an acknowledge message is
sent back to the AT-OME-MS42. Refer to the User Manual for the display device for more information. If the
command must be repeated, continue with the following steps. Otherwise, skip to step 13.
a. Under
Repeat Command
, click the
Status
toggle switch to the
ENABLE
position.
b.
Click the
Times
drop-down list and select the number of times which the command must be sent to the
device, before an acknowledge message is returned. The available values are 2, 3, and 4.
13. If
Generic
was selected as the manufacture, in step 10, then manually enter the required strings for each
operation. Refer to the following for information on formatting command strings on the next page.
