Atlas Copco LH804, Инструкция по безопасности и эксплуатации

Страница: 23 / 37

♦ Mount the cable on the transmitter.
♦ The machine is ready to use. Use the same
procedure for start/stop and operating as when
using radio control.
♦ When cable control is used, the transmitter battery
is not needed. The transmitter receives power via
the cable.
Control
♦ Forward operation:
Move the joystick forwards.
♦
Reverse operation:
Move the joystick backwards.
♦ Right operation:
Move the joystick to the right.
♦ Left operation:
Move the joystick to the left.
♦ Stop the machine and vibrator:
Release the joystick to stop the vibrator and the
machine will stop.
When taking a break
♦ Stop the machine during breaks.
♦ During all breaks you must put the transmitter
away so that there is no risk for unintentional start.
Parking
Always park the machine on the most level ground.
Before leaving it:
♦ Turn off the engine and the transmitter.
♦ Store the transmitter securely to prevent
unauthorized start of the machine.
Maintenance
WARNING Scalding hazard
During maintenance there is a risk of scalding from
hot engine oil.
►
Always ensure that the engine is cold before
performing any maintenance.
Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
♦ Before starting maintenance on the machine, clean
it in order to avoid exposure to hazardous
substances. See “Dust and fume hazard”.
♦ Use only authorised parts. Any damage or
malfunction caused by the use of unauthorised
parts is not covered by warranty or product liability.
♦ When cleaning mechanical parts with solvent,
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
♦
For major service of the machine, contact the
nearest authorised workshop.
♦
After each service, check that the machine's
vibration level is normal. If not, contact the nearest
authorised workshop.
Battery
NOTICE Do not use a quick charger when charging
the battery. This may shorten the life of the battery.
NOTICE When welding on the machine, the positive
and the negative terminals of the battery must be
disconnected. Never connect the welder grounding
cable to the diesel engine. Disconnect all cables from
the receiver and ECU before performing any welding
on the machine.
© 2013 Atlas Copco Construction Tools AB | No. 9800 1387 01 | 2013-07-01
Original instructions
22
LH 804 Safety and operating instructions