Atlantis Splash Tech R60 2nd Stage, Руководство по обслуживанию

Страница: 10 / 42

Use the 6” and 8” adjustable wrenches to loosen the hose nut from the COUPLING (12).
Remove the hose assembly from the second stage. Inspect the hose assembly for any cuts or
cracks, especially on the hose at the metal ferrules. If found, remove and discard. Check the
O-rings on each end of the hose. Clean, rinse, and blow-dry the interior bores of the hoses.
Replace the hose if any cuts or cracks are found.
Examine the condition of the mouthpiece. If it's in good condition you don't need to remove - it
can be re-used. Remove the mouthpiece by cutting the cable with side cutting pliers. Discard
the old mouthpiece tie.
4.2 DISASSEMBLY OF THE SECOND STAGE
! WARNING !
NEVER tighten the hose fitting to the first stage with more than 40 in. lbs.
(4.5 Nm) of torque. The inlet hose fitting can be weakened by over tightening.
To view the complete parts list of the second stage, open the front cover of
this manual.
4.2.1
Use the 6” and 8” adjustable wrenches to loosen the hose nut from the
adjust tube (18). Remove the hose assembly from the second stage.
Inspect the hose assembly for any cuts or cracks, especially on the hose
at the metal ferrules. If find Remove and discard the O-rings from each
end of the hose. Clean, rinse, and blow-dry the interior bores of the hoses.
Replace the hose assembly if any cuts or cracks are found.
4.2.2
If the mouthpiece is in good condition, you can don’t remove and be
reused. If not good to remove the mouthpiece (1)
by cutting the
mouthpiece tie (2) with side cutting pliers. Discard the old mouthpiece
tie. Examine the condition of the mouthpiece.
4.2.3
Put the exhaust cover (5) into the hot water for a moment. Remove the
exhaust cover (5) from the housing by pulling it back.