ATEN VM0808H, Руководство пользователя

Страница: 40 / 78

VM0808H User Manual
30
IR Remote Control Operation
The remote control allows you to change the Output port status of each display
using the IR remote control device included with your VM0808H.
You can use the remote control to: change the Input source of any Output
display, power on/off individual Output displays, or power on/off all Output
displays simultaneously.
Before using the remote control you must first plug the IR External Receiver
into the rear of the VM0808H and place the receiver where the IR signal can
be reached (see
External IR Receiver Port , page 6).
Change the Input source of an Output display
To change the Input source of an Output display, with the remote control, do
the following:
1. Press the OUTPUT port number (1–8) you want to change.
2. Within 2 seconds press the INPUT port number (1–8) you want the
OUTPUT port to display.*
3. Repeat steps 1-2 to change additional ports.
*For the change to occur the INPUT must be pressed within 2 seconds
of pressing the OUTPUT number.
Power on/off individual Output displays
To power on/off individual Output displays, with the remote control, do the
following:
1. Press the OUTPUT port number (1–8) you want to power on/off.
2. Within 2 seconds press the ON or OFF pushbutton.*
3. Repeat steps 1-2 to change the power status back on/off.
*If the ON or OFF pushbutton is not pushed within two seconds of
pushing the OUTPUT’s port number, all displays will be brought to a
powered on or off status, respectively.