ATEN VK0100, Руководство пользователя, Страница: 55 / 302

Chapter 2. Hardware Setup and Panel Oper
-
39
1. Prepare the installation site.
a) Choose a location where cables are free of interference.
b) Prepare a recession in the wall to accommodate the Control Pad.
Download a CAD diagram from the product web page.
2. Connect the Control Pad to serial, relay, and/or digital input devices using
the supplied terminal blocks.
For details, see
RS-232 Serial Connection , page 43, Relay Connections ,
page 44, Digital Input Device , page 45 respectively.
Note: To expand connection ports on the Control Pad, install ATEN
Expansion Boxes.
3. To use PoE, connect the Control Pad to a PoE switch via an Ethernet cable.
For details, see Ethernet , page 46.
4. If you do not have power sourcing equipment for PoE, contact your local
sales representative to purchase a power adapter and then follow the steps
below to prepare the power cord.
a) Cut the connector end of the power adapter.
b) Strip 5 mm (0.5 cm) off the insulation cover of the power adapter cable
to expose the +5V wire and the grounding wire.
c) Insert the 5V wire and the grounding wire tightly into the
provided 2-pin terminal block connector.
Note: Use a voltmeter to determine the polarity of an exposed wire.
d) Plug the power terminal block to the DC power port on the Control Pad.
+5V
+5V
GND
GND
5mm (+)
(-)
4a
4b
4c