Rapid Dialing
4 To program other features, you must dial
✱✱
to exit
Automatic Line Selection. Dialing
✱✱
applies only to
exiting the Automatic Line Selection programming
routine. Otherwise, leave programming mode by
sliding the T/P switch to the center position.
NOTE:
Digital phones: Dial #00.
There are three features that can be programed onto voice
terminals to allow the user to rapidly dial calls; Outside
Auto Dial, Last Number Redial, and Saved Number
Redial.
Outside Auto Dial An Outside Auto Dial button can be
used to dial telephone numbers, account numbers, and
PBX, Centrex, or Custom Calling feature
codes, with one
touch. To program an Outside Auto Dial
these steps:
1
2
3
4
5
Label a button.
Enter programming mode by sliding the T/P switch to
P.
NOTE:
Digital phones: Dial #33.
Press the button you want to program.
Dial
✱
90 and, if required, a Pool Access number and
two pauses (press Hold twice) plus a telephone
number or a PBX or Centrex code.
You may need to program a pause, stop, or switchhook
flash into an Outside Auto Dial sequence, or you may
need to switch from rotary to Touch-Tone signals in
the middle of a programmed dialing sequence. To do
so, you must enter the following special character
when you program the sequence.
> To program a pause, press Hold.
> To program a stop, press Drop.
3-118 Programming Voice Terminals
Содержание administration and
