AT&T administration and, Руководство по установке и обслуживанию

Страница: 242 / 404

Refer to Form 1a, System Form- Incoming Lines and/or
Form 1b, System Form-Tie Lines for Release 3, and the
Master Planning Form, Line Jacks for Feature Module 2
which shows how each line jack should be administered.
Follow the steps below to add or remove lines from the
main pool. If a line should be assigned to a different line
pool, perform that step as well.
With a Display Console
1
Enter administration mode by sliding the T/P switch to
P.
2 Press Conference twice.
The administration menu appears.
5Press
[Lines], [pools].
4 Dial the pool code (the default codes are 9 for the main
pool and 890 through 899 for the other pools).
5 Press
[Enter]
6 Press the line buttons until the appropriate code shows
for each line:
Red light
on
=
the line is assignd to the pool
Red
light
off = the line is not assigned
to
the pool
7 Press[Exit], and repeat steps 4 through 6 to administer
any other line pools.
8 Press Conference to return to the administration menu
or leave administration mode by sliding the T/P switch
to the center position.
With a BIS-34D Console
1 Enter administration mode by sliding the T/P switch to
P.
2 Press Conference twice.
Lights flash next to Adm Tel, Adm Pool, Message, and Speaker.
3-34 Administering a New System