AT&T 1337, Руководство пользователя

Страница: 6 / 10

beeps once, and continues with the next message. If there are no more messages stored in memory, the
system beeps four times.
Any time before you reach the end of the messages, you can replay a deleted message by pressing and
releasing REPEAT repeatedly until the message number is displayed. After the system reaches the end of
the messages, any messages that were not deleted are renumbered, and the Message Window shows the
total number of messages remaining in memory.
Recording a Memo
You can record a memo to be stored by the system as an incoming message. You can then play the memo
at home or from a remote telephone, like any other message.
1. To record a memo, hold down memo. When the system beeps, speak toward the front of the system.
While you are recording, the Message Window shows the length of the memo in seconds.
2. To stop recording, release MEMO.
When you release MEMO, the system stores the memo with your messages and updates the message count.
To listen to the memo, follow the instructions under “Listening to Your Messages”.
Remote Operation
You can use many features of the Answering System 1337 when you are away from home. To protect your
privacy, most features can be used only after you enter a two-digit Remote Access code.
NOTE: To enter your Remote Access code and use other remote features, you must call from a
touch tone telephone.
Remote Access Code
The Remote Access code is preset to 10. You can use the preset code or choose one of your own.
Displaying Your Code
Hold down CODE. The Remote Access code appears in the Message Window.
Changing Your Code
The Remote Access code can be changed from the preset code to any number from 10 to 99.
1.
Hold down CODE. The Remote Access code appears in the Message Window.
2. While holding down CODE, press and hold REPEAT to decrease the code or press and hold
FORWARD to increase it.
3. Release CODE when the desired code is displayed.
4. To see the new code, hold down CODE. The new code appears in the Message Window.
NOTE: If AC power fails and you have no battery installed (or the battery is low on
power), the Remote Access code returns to the factory setting of 10.
Using Your Code
To enter your Remote Access code:
1.
Dial your telephone number from a touch tone telephone.
2. Enter your Remote Access code when the system answers. When the Remote Access code is entered
correctly, the system beeps twice, indicating that it is ready for a remote command.
NOTE: To bypass the announcement (or if the MESSAGES switch is set to NO), enter your Remote
Access code as soon as the announcement begins. If the announcement does not stop, enter it again.