ring at least three times before the system answers. You can then hang up after the third ring to avoid
paying long distance charges.
CAUTION:
The Toll Saver feature works only if the system is on and memory is not full.
Otherwise calls are answered after 10 rings.
Message Indicator Displays
The Message Window and the Message Indicator Light tell you about the system’s status. The Message
Window shows a one or two character code to give you information about the feature being used. The
Message Indicator Light shines when the system is set to answer calls, and blinks when you have received
messages (or flashes when memory is full).
The table below tells you how to interpret the information provided by these displays.
Message
Window
Message Indicator
Light
What it Means
0
On (steady)
System is turned on, but you have
no messages
(blinking)
On
No announcement is stored in
memory
0 – 60
On
When recording an announcement
or memo, Message Window shows
length in seconds.
AP
On
Playing your announcement
--
On
Answering a call
1 – 50
Blinking slowly
On
Message Window shows current
message count.
Message Window shows number of
message being played
AO
On
Announce Only feature is on
Lo
On
Lo alternates with current message
count when battery power is low
10 – 99
N/A
Remote Access code is displayed
when you press CODE
64 – 0
Flashing rapidly
Formatting digital memory, after
pressing RESET or after AC power
failure with no battery backup
7 – 50
Flashing rapidly
Memory is full; you must delete
messages before new messages can
be recorded.
n/a
Off
System is not set to answer calls
Listening to Your Messages
Before playing your messages, adjust the speaker volume to the middle setting.
To play all messages and memos, press and release PLAY.
The system begins playing the first message stored in memory. As the system plays each message, the
Message Window shows the number of the message. The system beeps once after each message and four
times after the last message has been played.
The following choices are available during message playback.
•
To repeat a message, press and release REPEAT.
The system resumes playing at the
beginning of the message.
Содержание 1337
Страница 10: ......