3
Safety regulations
General regulations
Intended use
Standards and regulations
General regulations
This document contains important
information with regard to safety and
reliability of the installation, its commis-
sioning and the operation of the ATAG
XL W L boiler. All described activities
must be carried out exclusively by
authorized technicians.
Only original parts may be used; in
contrary cases, our warranty and gua-
rantee provisions are excluded.
Intended use
The ATAG XL W is a condensing and
modulating gas boiler, which is sus-
pended from walls and is delivered with
a pre-mix burner. The maximum target
temperature of the boiler is 90°C.
Standards and regulations
All applicable standards (both European
and national) must be observed during
the installation and operation of the
ATAG XL W boiler, including:
-
Local building regulations, with
regard to the installation of heating
facilities and waste gas exhaust
systems;
-
Regulations about a connection to
the electrical utility network (mains);
-
Regulations of the local gas utility;
-
Standards and regulations
concerning safety facilities for
heating systems;
-
Additional local laws/regulations,
which are applicable to the
installation and operation of heating
systems.
-
See the chapter “Commissioning”,
for those regulations applicable
to heating water and warm water
quality.
7KH$7$*;/:ERLOHULV&(FHUWL¿HG
and conforms to the following
European directives and standards:
-
92 / 42 / EEC
(ႈFLHQF\RIKRWZDWHUKHDWLQJ
systems
-
2016 / 426 / EU
Gas appliance regulation
-
2014 / 35 / EU
Low voltage directive
-
2014 / 30 / EU
EMC
directive
- EN
15502-1
5HTXLUHPHQWVIRUJDV¿UHGV\VWHPV
– Part 1: General requirements and
tests
- EN
15502-2
5HTXLUHPHQWVIRUJDV¿UHGV\VWHPV
– Part 2-1: Type C such as B2, B3
and B5 with nominal caloric debit
=< 1000 kW
-
EN 55014-1 (2011) EMC –
Requirements for household
appliances, electrical tools and
similar equipment – Part 1:
Emissions
-
EN 55014-2 (2008) EMC –
Requirements for household
appliances, electrical tools and
similar equipment – Part 2: Safety -
product family standard
-
EN 61000-3-2 (2013)
Electromagnetic compatibility
(EMC) - Part 3-2: Framework
conditions - framework conditions
IRUFXUUHQWÀXFWXDWLRQVFXUUHQW
drain 16 A per phase)
-
EN 61000-3-3 (2014)
Electromagnetic compatibility
(EMC) - Part 3-3: Framework
FRQGLWLRQVIRUYROWDJHÀXFWXDWLRQV
YROWDJHORVVDQGÀLFNHULQSXEOLF
low-voltage networks, for equipment
with a nominal 16 A current per
phase, which are not subject to any
special connection regulations.
-
EN 60335-1 (2011) Household
and similar electrical equipment
- Safety - Part 1: General
requirements
-
EN 60335-2-102 (2006/A1-2010)
Household and similar electrical
equipment - Safety - Part 1:
Special requirements for gas, oil
DQGVROLGIXHO¿UHGHTXLSPHQWZLWK
electrical connections
It is necessary that the currently valid
local normatives will be observed.
UK:
British Standards
-
BS 5440 - BS 6644 - BS 6891 -
BS 7074 - BS 8552 -
BS EN 60335 Pt1 - BS EN 12828
IGEM Documents
-
IGE/UP/1&1A - IGE/UP/2 -
IGE/UP/10
UK Regulation
- Clean Air Act 1993
- IEE
Regulations
- Building
Regulations
-
Gas Safety (Installation & Use) Reg.
Other Guidance
-
ICOM - BSRIA Documents
BG29/2012
-
BG50/2013 - CIBSE Guides
(B1, C, F)
-
HSE - INDG 436
Incorrect operation can cause
damage to the boiler and system
components and has the potential
to introduce hazards. Only persons
with appropriate knowledge and
TXDOL¿FDWLRQVVKRXOGEHDOORZHGWR
make adjustments to the boiler and
associated equipment.
The equipment may not be
XVHGE\FKLOGUHQE\SHUVRQV
ZLWKDKLQGUDQFHRIERGLO\
PHQWDORUVHQVRU\FDSDFLWLHV
RUZKLFKLQVXႈFLHQWH[SHULHQFH
DQGNQRZKRZXQOHVVWKH\DUH
supervised or have received
corresponding instructions.
It must be ensured that children
cannot play with the equipment.
