Atag HIDD9471LV, Инструкция по эксплуатации

Страница: 33 / 52

EN 9
USE
Be careful with enamelled sheet-steel pans!
The enamel may chip (the enamel comes
loose from the steel), if you switch the hob on at a high setting when the pan is (too) dry;
the base of the pan may warp - due, for example, to overheating or to the use of too
high a power level.
• Never use pans with a misshapen base. A hollow or rounded base can interfere with
the operation of the overheating protection, so that the appliance becomes too hot.
This may lead to the glass top cracking and the pan base melting. Damage arising
from the use of unsuitable pans or from boiling dry is excluded from the guarantee.
Minimum pan diameter
• The diameter of the bottom of the pan must be at least 12 cm. You will achieve the best
results by using a pan with the same diameter as the zone. If a pan is too small the zone
will not work.
• The length of a fish-pan (oval pan), used on the Bridge zones, must be at least 22 cm.
Pressure cookers
• Induction cooking is very suitable for cooking in pressure cookers. The cooking zone reacts
very quickly, and so the pressure cooker is quickly up to pressure. As soon as you switch
a cooking zone off, the cooking process stops immediately.
Power level setting
The cooking zones have 9 levels. Beside it there is a level ‘boost’ (P). If you have switched on the
hob the required cooking zone can be chosen within the next 5 seconds. Set the power level by
touching the slider. At the first touch, the level is set according to the part of the slider that you
touch. By sliding along the slider, the power level setting is changed. By sliding to the right, the
level increasing, while sliding to the left decreases the level. When you move your finger away
from the slider, the cooking field starts to operate at the level set.
Boost function
• You can use the ‘boost’ function to cook at the highest power level during a short period of
time (max.10 minutes). After the maximum boost time the power will be reduced to setting 9.
• Boost function is not available in Bridge mode!
Boost power management
• Due to the restricted power of the induction hob, the boost function can only be set on
one cooking zone simultaneously (for both left or right cooking zones). When switching
a cooking zone to the boost setting the other active cooking zone will automatically be
set to a lower power.
▷
The setting, which are set to a lower power, will be flashing in the display.