Atag E 22C, Инструкции по установке и обслуживанию

Страница: 19 / 40

Installation & Servicing Instructions ATAG E-Series
19
8 Electrical connection
The appliance complies with the CE Machinery Directive 89/392/EEC. The EC Low Voltage
Directive 72/23/EEC and the EC EMC Directive 89/336/EEC.
A 230V -50Hz mains electrical supply is required fused externally at 5A.
The installation must continue to comply with:
United Kingdom:
- the national rules for electrical installations.
Ireland:
- the ECTI national rules for electrical installations
The appliance must be connected to an earthed socket. this must be visible and within
reach.
The following general stipulations also apply:
-
No changes may be made to the wiring of the appliance;
- All connections should be designed in accordance with the enclosed regulations.;
- Should it be necessary to change it, the mains power supply cable may only be
replaced with an ATAG mains power supply cable (item No. S4477300).
The ATAG room thermostat and controls must be connected to their allocated
connections. All other types or makes of room thermostats or controls which are
used must have a Volt free contact.
When using an on/off thermostat or control, it is possible that an anticipating resistance
must be installed in order to prevent too high temperature fluctuations. As a standard
rule this means mercury thermostats. This resistance wire can be ordered by your
supplier and must be connected to clamps 23 and 27. The anticipating resistance in the
room thermostat has to be set at 0.11 A.
For more detailed questions regarding the components which are not supplied, the
country distributor should be contacted.
boilercombinaties
tabel 6
Connection terminalE-Series
Connection terminal figure 10
mains power supply 230 Volts for external control 230 Volts internal or external three-way valve motor and cylinder sensor ATAG room thermostat On/off thermostat or control (Volt free) ATAG outside sensor
External safety contact
24 Volts maximum 100 mA