ATA SAPHIR 550, Руководство по эксплуатации

Страница: 17 / 42

»SAPHIR 550/560
Operating Manual
GmbH
- 17 - Stand: 03.02.2020
2.2.6.8 Progress indicator
This indicator at the bottom of the screen shows the progress in an automatic process or sequence.
The left-hand side shows the already elapsed time, i.e. for grinding of abrasion; this is the amount of abrasion which
has already been removed.
1 Already elapsed time/removed abrasion
2 Remaining time
2.2.7 Movement control
1 Save height position
2 Save side position
3 Release sample holder
4 Head upwards
5 Head downwards
6 Loosen brake (swing head left/swing head right)
2.2.7.1 Head movement
Use the 2 middle keys to move the head either upwards or downwards.
The head can only be moved downwards when it is directly above the working wheel; otherwise the head would press
down onto, and damage the housing.
Press the large key on the right-hand side to loosen a brake, so that the head can be swung to the left or to the right
by hand. Release pressure on the key and the brake comes back into effect.
If a position is memorized in the X- direction, then the brake stays loosened even after removing pressure from the
key. This enables you to swing the head with 2 hands.
If the head is to be found in the area of the working wheel, then the brake will begin to grip when it is swung too far
to one side or the other. This makes sure that the sample holder does not travel too far and hit the bowl.
» As the brake has a certain amount of technically-related delay in loosening, the head should only
be moved by hand with moderate speed.
» If the movement is too fast, then the brake position can be exceeded.
1 2
1
2
3
4
5
6