14
DCB-05V2 Gate Controller
Owner Installation Instructions
PRESS
New
transmitter
Fig 11.3
NOTE:
When a transmitter is remotely coded, its ID label is set to that
of the existing transmitter. If the existing transmitter does not have an
ID label assigned, then the ID label of the new transmitter is set to:
R/C Tx ###, where ### is the existing transmitters store number. This
ensures that the originator of any remotely coded transmitter can be
identified.
DCB-05V2 can be instructed, via its pedestrian control feature, to partly open and provide pedestrian access but prevent
vehicle access. This is achieved by partly opening the motor 1 gate leaf. If dual motors are used, motor 2’s gate leaf is
held closed. The partly open position of motor 1’s gate leaf is initially set to a position halfway between open and closed.
This initial position can be adjusted by the installer to any position within the gates travel range by selecting a pedestrian
access travel time (from closed). The setting is accessed from “MENU 10.4 Set Pedestrian”. The time is adjustable in
1 second steps.
12. Setting Pedestrian Position
PED’N Opening
TIME 5
PREV
NEXT
EXIT
SET
Fig 12.1
Fig 12.2
MENU 10.4
SET PEDESTRIAN
PREV
NEXT
EXIT
SET
PRESS
NOTE:
Before setting the pedestrian access position the gate
must be in the fully closed position. As with the Setting Travel
Limit procedure, a transmitter can be used to complete the
pedestrian position setting procedure.
12.1 Setting the Pedestrian Position
Navigating to “Menu 10.4 Set Pedestrian”
a. Press PREV to navigate to Menu 10.
b. Press SET - MENU 10.1 is displayed.
c. Press NEXT to go to MENU 10.4.
d. Press SET to enter Set Pedestrian procedure
(Fig. 12.1)
.
Setting pedestrian position
a. Press UP or DOWN arrows to adjust pedestrian drive time.
b. Press SET to record position
c. Press transmitter coded for pedestrian function or push button
wired into pedestrian input to test.
12.2 Checking Pedestrian Position
When activated by a transmitter button which is coded as Ped
mode, the opener drives the gate to the preset position. Ped
Mode’s active status is indicated on the display
(Fig. 12.2)
.
If a
Ped Mode button is pressed while the gate is moving, the gate
will stop. If a Ped Mode button is pressed when the gate is in the
Ped position, then the gate will close.
12.3 Error Displays
During the above procedure many error checks are performed. If
an error is detected, a message will be displayed indicating the
error.
11.2 Activate Remote Code Set Mode
a. Use a small pin to press and hold through the Coding Hole of the
existing transmitter for 2 seconds
(Fig. 11.2)
.
b. Within 10 seconds, press the button on the new transmitter you
wish to code for 2 seconds
(Fig. 11.3)
.
c. Press the same button again (within 10 seconds)for confirmation.
d. Test Operation. The new transmitter button should now function as
the existing transmitter.
11. Remotely Coding Transmitters
Existing
transmitter
Fig 11.2
