16
CONFIRMATION
When the alarm is armed, one chirp of the siren and/or flash of the parking lights means that all protection zones are in normal condition and that the system is
ready.
The remote control sends the following confirmation
with one soft chirp.
Three siren chirps or parking flashes means that one or more zones are in violation (i.e. at least one door is opened). At that time, the remote sends the same
confirmations but with a high chirp, reminding you to correct the violated zone.
Once the zone is corrected (i.e. door is closed), the system sends another confirmation (one chirp or flash if all zones are in normal condition, three chirps or
flashes if another zone is in violation).
If a zone is in violation when the system is armed manually (using the remote) and the cause of the violation is not corrected, the alarm will still arm but this zone
will not be able to generate an alarm condition. See also "DOME LIGHT DURATION" on page 21.
When you disarm the alarm, two chirps or flashes indicate that no one tried to break into or do anything to your
vehicle, and four chirps or flashes indicate that an alarm condition occurred during your absence. Your remote will
also indicate this with chirps as shown in the following table.
The following table summarizes this section.
CONFIRMATION
chirps or flashes
MEANING
1
System armed, no zone in violation.
2
System disarmed, no violation detected.
3
System armed with zone in violation. Indicator light indicates which zone.
4
System disarmed with violation detected. Indicator light indicates cause of alarm condition.
INDICATOR LIGHT
The Indicator light flashes a specific number of times to indicate different alarm conditions when arming and disarming the system (depending on settings during
installation).
It can also act as a deterrent if installed in a place visible from outside the vehicle.
DURING ARMING
The indicator flashes codes for zones in violation (i.e. at least one door is opened).
Only one code is shown at a time. If more than one zone is in violation during arming, the code changes when the zone shown is corrected (example: door is
closed).
DURING DISARMING
The indicator light flashes the code for the last zone that generated the alarm condition.
The code is shown when you press the
button.
This code is repeated until you apply the brakes.
The following table shows the meaning of the zone codes (number of flashes).
ZONE CODES
Flashes
Zone indicated
1
System is armed.
2
A door is/was open.
3
Hood is/was open.
4
Alarm condition is/was detected on shock sensor input.
5
Key is/was in ignition position (RUN).
6
Alarm condition is/was detected on additional sensor input.
Additional sensor monitors status of ____________________________________________________
7
Loss of power (+12V battery supply was removed).
8
Alarm status is/has been detected on pre-shock sensor input.
THE INDICATOR CAN SHOW TWO OTHER CONDITIONS:
CONSTANT DIM LIGHT
Indicates that alarm is permanently disarmed.
See "VALET MODE" on page 17.
RAPID FLASHES
Indicates that system is in rearming cycle.
See "SEMI-PASSIVE REARMING" and "PASSIVE REARMING" on page 15.
Condition
Confirmations
Without violation
2 soft chirps
With violation
1 loud chirp
