AstroNova QuickLabel QL800, Руководство пользователя

Страница: 33 / 172

Getting Started
QL-800 User Guide 33
6 Tighten the fastener on the outer flange [4] until you feel resistance. This secures the outer
flange in place.
7 On the front of the printer, slide the media exit guide [5] all the way to the right toward the
control panel. You can adjust this guide before printing.
8 Place the media near the entry slot and slide the adjustable media guide [6] to the width of
the media. The edges of the media should lightly contact the edges of the fixed media guide
[7] and the adjustable media guide [6].
9 Slowly guide the media into the printer as illustrated. You will feel slight resistance as the
media enters the roller area. Make sure there is no excessive slack in the media during this
process.
10 The printer will beep three times to indicate the media has been detected. Release the
media when the printer starts automatically feeding it into the printer. The printer will feed
media and the loading process will be complete.
Loading Media with Manual Feed Mode
In most cases, the standard media loading procedure is the best method for installing a label
roll. If you experience multiple failures using the standard method, use the alternate method
described in this section.
Note: This procedure applies only to printers with firmware version 1.1 or later.
1 Turn the wing nut [1] on the end of the mandrel counterclockwise to loosen the mandrel.
2 Loosen the fastener on the outer flange [4]. Then remove the outer flange from the mandrel.
[6]
[7]
[6]
[7]
[1]
[2]
[4]
[3]
[5]