Installation
900921-00E, 06/2019
Innovative Hearth Products
Aries™ -C Series Direct-Vent Gas Fireplaces
46
Figure 36A - Facade Installation
Figure 36B - Barrier Assembly Replacement - Classic Frame
Facade Installation - All Facades
(see Figure 36A)
1.
Install the facade (with barrier) using the four shoulder screws
that are installed in unit.
2.
Hang the top of the facade on the top shoulder screws first
than lift the facade up (using your thumbs to stabilize facade)
and install on the bottom shoulder screws.
Barrier Assembly Replacement - Classic Frame Facade
(see Figure 36B)
If the screen mesh barrier gets damaged it shall be replaced prior
to operation of the fireplace.
1.
Remove the current barrier by placing the facade on a flat
surface face down and removing the four retainer screws and
the modesty panel.
2.
Slide the barrier out and replace with the appropriate barrier
and then secure the new barrier in place using the four screws
and modesty panel. Be sure the screen is turned to be flush
with the front of the facade as shown in
Figure 36B
.
Top Shoulder
Screws
(1 ea, side)
Bottom Shoulder
Screws
(1 ea, side)
Mesh Barrier
facade
(with barrier)
Mesh Barrier
Secure the new barrier in
place using the four screws
and modesty panel
Slide the barrier out and
replace with the appropriate
barrier
Install the facade
(with barrier)
Install the facade
(with barrier) using the 4
shoulder screws
NOTE
: Classic Frame facade will adjust out 1/2”; the Craftsman,
Artisan, and Reflection facades will adjust out 1” to accommodate
noncombustible finishing materials.
Artisan
(only one color, which is shown)
Reflection
(warm chestnut shown, black not shown)
Craftsman
(Warm Chestnut shown, black not shown)
Classic Frame
(only one color, black, which is shown black)
Facades
NOTE
: See
Page 47
for Barrier Assembly Replacement instructions
for Craftsman, Artisan, and Reflection facades
WARNING
LIFTING HAZARD
SINGLE - PERSON LIFT COULD
CAUSE INJURY.
USE ASSISTANCE WHEN
MOVING OR LIFTING.
NOTE
: It is recommended to use the remote when using Craftsman,
Artisan, and Reflection facades as the lower compartment area will
be harder to access.
