Inst 276 - Viron Connect Pool & Spa Controller V0610
10
POOL AND SPA EQUIPMENT CENTRE
INSTALLATION AND CONFIGURATION
WARNING!
This appliance must be installed in accordance with AS/NZS 3000:2007
The Viron Connect touchscreen console, additional console, FM remote and Viron Connect 8
consoles are connected to the Power Supply Module, AstralPool Heater and Salt Chlorinator and
Viron P300 Pump by 6 wire flat cable with RJ12 connectors.
The Cable with RJ12 Connection to the Pool Heater and Handset must be installed before power is
supplied to the Power Supply Module.
The combined load of equipment operated must not exceed 40 Amps.
The Power Supply Module must be hard wired by a licensed electrician. To avoid a safety hazard,
the supply cord if damaged, must only be replaced by Hurlcon, or its service agent or a suitably
qualified person.
-
Supplied by an isolating
transformer
-
Supplied through a residual current device (RCD) with a rated residual
operating
current not
exceeding 30mA
An approved Isolation Switch must be installed in the electrical supply to the Power Supply
Module.
The Pool and Spa Equipment Centre is not intended for use by young children or infirm persons
without supervision. Please ensure that young children are supervised to ensure that they do not
play with the Pool and Spa Equipment Centre.
The FM Control handset is not water resistant. Therefore water must be avoided.
CONTROL BOX INSTALLATION
The Viron Connect Pool and Spa control has a Rating of IPX3 enabling it to be installed outdoors. Regulations
require that the control is not allowed to be located within 3.5 metres of the pool water.
The control should be installed in a well ventilated position ideally away from direct sunlight. Ensure that the unit is
not located near pool chemicals as fumes may damage the control.
Included in the kit is two green masonry plugs and screws. When installing on a brick or concrete wall, use a
7mm masonry drill. Mounting Screws should be 180mm apart and located at least 1600mm above ground level.
When installing the control on a post, first attach a flat waterproof panel at least 300mm high by 500mm wide.
Make sure the control is located centrally on the panel and sits flat.
