Astralpool Viron Connect 10, Инструкция по установке и эксплуатации

Страница: 51 / 76

51
Section 12. Custom Switching (from external source)
10.1 The Viron Connect controller has the ability to accept two external switching inputs that allow for
the operation of Favourite settings. The switching is controlled through a momentary pulse signal
which will turn the selected Favourite on. A repeat pulse will re-­‐confirm the favourite is to be on,
it does not turn the favourite off. To turn the active favourite off and return to normal pre-­‐
programmed settings, the “All Auto” function must be selected from the Home menu.
10.2 For most installations using this feature the set up will be;
CUSTOM SWITCH 1 -­‐ This will be programmed as one of the owners favourites
CUSTOM SWITCH 2 -­‐ This will be programmed as ALL AUTO
You cannot use CBUS to operate all features of the Connect 10. Temperature control, timers etc must still be
operated through the touchscreen.
You can only operate 2 selected functions through CBUS, you cannot operate all 8 channels.
10.3 To connect to the custom switches;
i. A 2 wire cable (low voltage) needs to be run from the named terminals on the Viron
Connect back to the external controller (CBus or other home automation system)
ii. The switching terminals require a momentary pulse of an open/close contact. Note: the
external controller must not supply any voltage back to the Viron Connect.
iii. In the Touchscreen installation setup (Section 7) when prompted select Yes to activate
the use of external custom switches.