Astralpool Viron Connect 10, Инструкция по установке и эксплуатации

Страница: 20 / 76

20
6.1 Control Box Installation
a. The Viron Connect 10 electrical box has an IPX3 rating enabling it to be installed outside.
Regulations within AS/NZS 3000:2007 require that the electrical box be installed outside of
the pool zone. This pool zone extends 3.5m from the edge of the swimming pool.
b. The electrical box should be installed in a well ventilated position, away from direct sunlight
and out of the direct weather where possible. Ensure the unit is not located near pool
chemicals as fumes may damage the sensitive electrical components.
c. The electrical box is supplied with masonry plugs and screws. When mounting onto a solid
wall, ensure the lowest part of the controller is a minimum of 1600mm above ground level. If
being mounted onto a post, a flat weatherproof panel must be used behind the equipment
box. This panel must extend 150mm past each side and top/bottom of the controller.
6.2 Touchscreen Installation
a. The touchscreen supplied with the Viron Connect controller system is designed for
indoor installation only. Connection of the touchscreen to the electrical control box
is made by a 6 wire RJ12 straight through cable. If cable connection back to the
electrical box is not possible, a wireless link module can be purchased from
AstralPool.
b. To mount the touchscreen controller, using a flat blade screw driver release the
locking tabs located at the top and bottom of the touchscreen and carefully remove
the back cover. After connecting the cable to the rear of the screen, attach to a wall
using the mounting holed provided.
c. Slide touchscreen back onto rear cover ensuring locking tabs clip back into location.
375mm
480mm
View of rear side of
touchscreen