3 Programming
The recommended programming order is setting the pages of the device, starting from the first device,
and setting the commands of the page from the first button. Furthermore, the recorded commands
should be immediately entered on the programme chart. Any of the settings can be altered later: new
commands and pages can be added, or commands and even entire pages can be removed, etc.
3.1 Programming of single commands
Adding of fixed individual commands on the pages is carried out as follows:
1) Wake up the device by pushing a button from 0 to 9. The led of the selected page lights up.
2) Enter the programming mode by pressing C + D + E simultaneously; the Prog-led lights up.
3) Enter the command programming mode by pushing the button 1. It is possible to add
maximum of three IR commands to one button.
4) Select the page on which you wish to add a command by pressing the page number (numeric
buttons 0–9). The led of the page lights up to indicate the selection.
5) Select the button to which you wish to add the command by pushing 0–E. The led of the
button starts blinking to indicate the selection.
6) Select the desired format (See description of IR-formats in (
appendix 1
).
7) Select the desired programming command for the format (
appendix 1
).
8) Store the entered command by pushing the button A or cancel the action by pushing the button
B. If necessary, you can send a text command by pushing the button E, in this case the device
will repeat the set command; after this you can either store or cancel the command. After the
selection the device returns to action 5).
9) By pushing the button C continuously for about 2 seconds you will return to action 2). By
pushing the button C again for 2 seconds the device will return to the standby mode.
3.2 Programming of commands of an entire page
Adding the commands of an entire page is carried as follows:
1) Wake up the device by pushing a button from 0 to 9. The led of the selected page lights up.
2) Enter the programming mode by pressing C + D + E simultaneously; the Prog-led lights up.
3) Enter the programming mode of commands of an entire page by pushing the button 2.
4) Select the page, to which you want to add a command, by pressing the page number (numeric
buttons 0–9). The led of the page lights up to indicate the selection.
5) Select the desired format from (
appendix 1
).
6) Select the desired programming command for the format (
appendix 1
).
7) Store the entered command by pushing the button A or cancel the action by pushing the button
B. After the selection the device returns to
action 4).
8) By pushing the button
C
continuously for about 2 seconds you will return to action
2)
. By
pushing the button
C
again for 2 seconds the device will return to the standby mode.
