9
2
Drill holes into the wall using the knockout holes on
the base as a template.
3
Fit wall plugs and secure the PIR base with the
screws provided.
4
Fit the PIR back together and tighten bottom
screw, the PIR installation is complete.
Mounting the Keypad:
1
Drill holes into the wall using the fixing holes as a
template.
2
Fit wall plugs into the wall and fix back cover with
the screws provided. Put the keypad into the
bracket.
Mounting the Door Contact
Frame
Door/Window
Gap no more
than 10mm
Magnet
Sensor
Sensor
ale
Y
1
Find a location on the door/window where you
would like the device to be mounted. The sensor
should be on the frame while the magnet should
be on the door/window. Once mounted make sure
the tamper switch spring is fully depressed.
The gap between the magnet and sensor should
be no more than 10mm when closed (maybe
shorter depending upon the actual environment).
Simple test to see whether the magnet is in range
of the sensor: hold the magnet and sensor in
place and then pull them apart. If the sensor LED
lights up it implies the two items are within range.
i
-Mounting using adhesive pads
Clean the mounting surface with a suitable
degreaser agent. Please note that some surface
or environment (i.e. exposure to Sunlight) maybe
unsuitable for this mounting method. Please use
screw mounting in these cases.
-Mounting using screws and wall plugs
Loosen the bottom screw
and open the door/window
contact. Knock out the holes
on the base as shown. Drill
holes into the mounting
surface using the holes in
the knockouts on the base
as template. Fit wall plugs
(if required) and secure with
the screws provided.
Mounting the Help button
1
Break through the knockouts (where the plastic is
thinner).
2
Using the holes as a template, drill holes in the
surface and insert wall plugs if fixing into plaster or
brick. Screw the rear case to the wall.
3
Replace the cover and tighten the screw.
Mounting the Smoke Detector
1
The base has two mounting slots. Using the slots
as a template, drill holes and insert the wall plugs if
fixing to plaster. Screw the rear case to the ceiling
using the screws provided.
2
Replace the main unit onto the bracket.
Knockouts
Corner fixing
knockouts X 4
Wall fixing
knockouts X 2
Fixing Slots X 2
Keypad
Cradle Open
