14
1
Select the Log menu and press
3
.
2
The log can now be scrolled up and down and
viewed with the
st
keys; the most recent event
will be at the start.
3
The first line displays the time and date of the
event, the second line displays the type of event
and the third line either states the user or the
device that caused the event. Abbreviations used
are:
· “
LB”: low battery
· “
Tamp”: tamper
· “
R”: restore.
·
AC: mains power
·
Panic: emergency
·
Perimeter: entry or away entry device
·
Cancel: silencing an alarm with a help button
Adv. Settings
The settings will initially have factory default values.
If you do not want to change them then you can
escape any menu by pressing
P
without making
changes.
The following items are available in this menu:
· Pin Code
· Entry Time
· Exit Time
· Entry Sound
· Exit Sound
· Door Chime
· Alarm Length
· C.U. Siren
· Jamming Det
· KF Entry
· Time
· Date
· Final Door
Pin Code
The PIN Code (password) is used to configure the
control unit and to disarm the system.
• To disarm, press the ‘disarm’ key followed by your
PIN code.
• To enter the program menu press the ‘menu’ key,
enter a PIN code followed by
3
.
• Up to 4 Pin codes can be stored.
1
Select ‘Pin Code’ then press
3
, a list of 4 PIN
codes will be shown, occupied codes are shown
with ****. The list can be scrolled up and down
using the
st
keys.
2
Select the code you want to change and press
3
, enter your new PIN code and press
3
. You will
be asked to repeat the PIN code, enter it again
and confirm by pressing
3
, You will now be asked
to name the PIN code. The new code is now
programmed.
•
P
can be used to correct entry errors, pressing
P
repeatedly will return you to the PIN code list.
• User 1 code can only be changed and cannot be
erased. All other codes can be erased by selecting
them and pressing
3
.
• An error message will be shown if either an
incorrect repeat code is used or a duplicate code
is entered for another user. All codes have to be
different.
Entry Time
Note: Ensure device is set to entry on control unit for
the entry time to work (see section 5, Add Devices)
Entry time gives you a delay to allow you time to
enter your premises and disarm the system. Times
can be set from 00 seconds (no delay) up to 70
seconds in 10 second increments.
• 20 seconds is the factory default.
Exit Time
Exit time gives you a delay to allow you to leave your
premises before the system arms. Times can be set
from 00 seconds (no delay) up to 70 seconds in 10
second increments.
• 30 seconds is the factory default.
Entry Sound
The control unit will beep during the entry delay
period as an entry warning, you can switch the
sound on and off with this setting.
• Entry sound on is the factory default.
Exit Sound
The control unit will beep during the exit delay period
as an exit warning, you can switch the sound on and
off with this setting.
• Exit sound on is the factory default.
Door Chime
Any door contact or PIR set to entry will cause
the control unit to chime when activated when the
system is disarmed. This is used to signal when
anyone has entered your premises. You can switch
the sound on and off with this setting.
• Chime off is the factory default.
