Assa Abloy Sentinel Digital Ph III RF-Online, Руководство по модернизации

Страница: 8 / 23

October 11, 2011 Page 8 of 22 66 3081 018-4
2.2.2 Connecting RFOI with inside PCB
1. Make sure that the 5-wire cable between endnode and RFOI is connected; see section 2.2.1
for details.
2. Insert the RFOI firmly until the snap will hold it; see 1 in the following picture. Be careful
about the cable between endnode and RFOI - the cable must be placed below the RFOI board
and behind the supporting tower; see 2 in the following picture. The flex cable connected to
the X2 connector should be bended upwards.
3. Connect the previously disconnected flex cable from the inside of the safe to the connector X1
on the RFOI board.
2.2.3 Connecting RFOI with front board
1. Connect the flex cable from the RFOI socket X2 to the front board.
2. When the cable is fitted properly, the front cover of the safe can be closed.
Note: Do not forget to insert the battery that was removed according to section 2.1.