Grade 1 Key-In-Lever VR Lever Lock
Installation Instructions
CL3100 Series
FM345 01/19
For Installation Assistance contact Corbin Russwin
1-888-607-5703 • [email protected]
Copyright © 2016, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
12
c
Install Lever
Important
Before installing levers read "Specific Instruction Per Function - Before
Installing Lever" on page 6.
1. Place cylinder in outside lever. Insert key and rotate 45° clockwise.
2. With key rotated, push lever onto sleeve until hole on inside of lever
is over security attachment screw. If screw interferes with assembly,
check that screw is fully threaded into lever catch.
3. Using screwdriver provided, rotate security attachment screw
counter clockwise until flush with surface of lever.
4. Secure lever with 6 lobe security set screw.
5. Rotate key to horizontal and remove.
Figure 22
Install Lever
14
Installation: CL3100 Lever Lock with High Security Lever (M111)
a
Assemble Lock Body
1. Prep door and install lock bearing and latch according to door and frame preps that appear on page 3 step 1.
2. Complete assembly of lock with security lever attachment according to the following steps.
b
Install Security Attachment Screw
1. Using screwdriver provided, unscrew the security
attachment screw from lever catch on the outside
sleeve.
Important
Keep screw for reinstallation.
2. Install outside and inside sleeves and roses
according to sleeve installation instruction on
page 6 step 6.
Note
The cam in the outside sleeve must be rotated so
the large slot is horizontal. This allows the security
screw to thread into the cam. See cam orientation,
page 7 step 7.
3. Insert the security attachment screw into lever
catch assembly and tighten until screw head is
within approximately 1/8" of lever catch. Do not
overtighten.
Figure 21
Security Attachment Screw
security attachment screw
1
lever catch
outside sleeve
cam
screwdriver
3
Outside sleeve
Cam
3
1
Lever catch
Screwdriver
Security attachment screw
2
1
5
4
3
6 lobe Security
Wrench
6 lobe security
wrench
45°
45°
