Grade 1 Key-In-Lever VR Lever Lock
CL3100 Series
Installation Instructions
FM345 01/19
For Installation Assistance contact Corbin Russwin
1-888-607-5703 • [email protected]
Copyright © 2016, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
5
3
Lock Disassembly
4
Latch Installation
1. Unthread and remove INSIDE collar and sleeve.
2. Unthread and remove OUTSIDE collar and sleeve.
Note
Push aligning pin out of the way of outside collar.
3. Remove aligning pin from bearing assembly.
4. Separate latch from bearing assembly.
Hold door open with door stop.
1. Insert bearing assembly.
2. Insert latch assembly.
3. Insert aligning pin from secure side
(outside) of door.
4. Install latch plate screws. Do not tighten
completely until lock installation is finished.
Figure 5
Lock Disassembly
Figure 7
Driver Tip Alignment
Lock
Disassembly
Latch
Installation
Figure 6
Latch Installation
5
Driver Tip Alignment
IMPORTANT:
Sleeves with colored driver tips require that
the slotted cam be rotated, allowing the spring
loaded spline adapter to move freely in and out
of the outside sleeve.
Driver tips with red markings must match up
before assembling lock. Test to ensure that
spline adapter can move freely.
NOTE
Some driver tips have two (2) color markings
for function identification. See chart on the
following page.
std core
IC
slotted cam
Outer
sleeve
IC
Spline adapter is
locked
Colored
driver tips
Slotted cam
Spline adapter
can move freely
Standard core
2
4
1
3
Outside
Inside
Outside
Inside
1
3
2
4
1
2
2
3
4
2
2
4
1
3
