Assa Abloy Corbin Russwin CL3100 Series, Руководство по установке

Страница: 8 / 16

Grade 1 Key-In-Lever VR Lever Lock
Installation Instructions
CL3100 Series
FM345 01/19 For Installation Assistance contact Corbin Russwin
1-888-607-5703 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2016, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
8
For functions not shown, proceed to step 9, Lever Installation.
Inside Sleeve
Function
Number
Function
Description
Outside Sleeve
Lock lever by button.
CL3120
Privacy/Bedroom/
Bathroom
Rotate cam with emergency key until lever
catch button can be depressed.
CL3161 Entry/Office
Rotate cam until lever catch button
can be depressed.
CL3151 Entrance/Office
CL3193 Service Station
CL3157 Storeroom/Closet
Align tailpiece and tailpiece slot in cam.
Rotate key 45° CW until lever catch
button can be depressed. Install lever.
CL3132 Utility/Institutional
Align tailpiece and tailpiece slot in cam. Rotate
key 45° CW until lever catch button can be
depressed. Install lever.
Rotate cam CCW until it stops. CL3172
Exits/Public Toilets/
Apartment
Rotate cam until lever catch button
can be depressed.
Rotate cam CCW until it stops. Then
rotate back 45° until lever catch button
can be depressed.
CL3162 Communicating
Rotate cam CCW until it stops. Then rotate
back 45° until lever catch button can be
depressed.
Rotate cam CCW until it stops. CL3152 Classroom Intruder
CL3155 Classroom
CL3175 Corridor/Dormitory Lock
Function Specific Directions - Lever Installation
9 Lever Installation
1. For conventional cylinder, place cylinder into lever.
Insert key and turn 45° CLOCKWISE to align cylinder
tailpiece with cylinder tailpiece slot in cam
(cam orientation - page 7 step 7).
NOTE
6-pin standard cylinder requires a spacer
for cylinder to seat properly in the lever.
For IC cylinder/lever removal and installation,
see page 10 step 13.
2. Install outside lever. Push on lever until lever engages.
3. Secure with 6 lobe security set screw until tight.
4. Install inside lever.
5. Secure with 6 lobe security set screw until tight.
6. Complete tightening of two (2) latch bolt screws.
7. Check operation of levers and latch bolt
before closing door.
Sleeve
Installation
Figure 12 Lever Installation
Figure 13 Lever Tails
TEST OPERATION:
Rotate levers to see that latchbolt moves
freely.
DO NOT FORCE .
If lockset does not
operate properly, remove lockset from door
and check door preparation.
Cam
(inside sleeve)
Lever catch
Tailpiece
Shown with
6-pin spacer
Outside
Inside
1
1
2
4
45°
3
5
6
Lever catch
Tailpiece
Shown with
6-pin spacer
Cam
(inside sleeve)
Outside
45°
Inside
5/8
7/16
6 PIN STD TAIL
AND SPACER
7 PIN
STD TAIL
7-pin
standard tail
6-pin standard tail
and spacer
7/16"
5/8"