Dual control mixer with diverter
6
PrePArING the MIXer VAlVe
Check the contents to make sure all parts are
present.
Before installing the mixer, make sure all the
openings on the valve are carefully covered to
stop ingress of any debris, etc.
The shower valve is suitable for installation
in a chased out cavity in a solid wall, a stud
partition wall, dry lined wall or fixing to a
shower cubicle or panel.
The hot and cold water pipes should not
be permanently attached to the wall within
one metre of the valve before installation is
complete to allow for final adjustment of the
valve position.
SItING oF the ShoWer
Refer to
(fig.6)
for correct siting of the
shower.
Position the shower and showerhead on the
wall so that all controls can be comfortably
reached while using the shower. The
showerhead can be positioned either side of
the shower.
The unit must be positioned horizontally with
the outlet port at the bottom.
ImpOrtant:
The hoT entry port is on the
left top and the Cold entry port on the
right.
Height of
showerhead
and shower
to suit user’s
requirement.
Shower can be
mounted either side
of the showerhead.
WarnInG!
the shower must not be positioned
where it will be subject to freezing
conditions.
note:
Suitable service valves (complying
with Water Regulations and Bylaws) MuST
be fitted on the hot and cold water supplies
to the shower as an independent means
of isolating the water supplies should any
maintenance or servicing be necessary.
Fig.6
(diagrammatic view — not to scale)
