Dual control mixer with diverter
10
FIttING the bUlKheAD
The bulkhead and its cover are supplied
assembled. Separate the two halves by carefully
prising apart at the smaller of the two elbow
apertures.
Secure the elbow to the bulkhead body with
the three screws supplied
(fig.11)
.
Screw the bulkhead assembly onto the
threaded connector temporarily. Mark the
position of the two fixing holes
(fig.12)
for
securing the bulkhead to the wall.
note:
If screw thread protrudes too far out
of the wall, it can be cut to the correct length
using a hacksaw.
unscrew and remove the bulkhead assembly.
Check the location of the pipe in the wall
before drilling.
Drill and plug the wall.
(An appropriate drill bit should be used. If the
wall is brick, plasterboard or a soft building block,
appropriate wall plugs and screws should be
fitted).
If fitting to a hollow wall structure, it may be
preferable to secure the bulkhead by applying
a bead of silicon seal to the back of the
bulkhead.
Apply PTFe tape to the threaded connector.
Screw the bulkhead assembly onto the
threaded connector until tight to the wall and
the two fixing holes are aligned. Secure to the
wall with the two screws supplied
(fig.13)
.
Finish by clipping the cover onto the bulkhead
making sure the protruding legs locate in the
bulkhead body.
Fig.11
Fig.13
Fig.14
Fig.12
