Aspect Medical Systems BISPECTRAL INDEX A-2000, Руководство по обслуживанию

Страница: 80 / 92

SECTION VII DISASSEMBLING AND REASSEMBLING THE A-2000™
- 7-27 -
7.11
FUSE REPLACEMENT
The A-2000 contains two inline fuses (1.25A, 250V, 5x20mm Aspect P/N 430-0006)
within the AC power input module located at the rear of the monitor. In the unlikely event
that a fuse needs to be replaced, one can access these fuses as follows:
1. The fuse holder is part of the AC power input module on the rear of the monitor and is
located just above the power cord input connector.
2. Disconnect the AC power cord from the wall socket and from the rear of the monitor.
3. Locate the plastic locking tabs securing the fuse holder in place.
4. Insert the tip of a ball point pen or similar tool, into the slots provided to release the
plastic locking tabs allowing the fuse holder to spring out of its locked position. (See
Figure 7-21).
5. To re-install the fuse holder, simply insert the fuse holder and press in with finger until
the plastic locking tabs engage securing the fuse holder in place. (See Figure 7-22).
WARNING!
FOR CONTINUED PROTECTION AGAINST FIRE OR DAMAGE,
ALWAYS REPLACE OLD FUSE WITH THE SAME FUSE TYPE AND
RATING.
Caution:
A burned out fuse usually indicates a serious problem with the electrical
system of the A-2000 unit. Call service before attempting to remove and
replace a fuse.