- 49 -
6
Troubleshooting
6.1
Factory Default
To execute the Factory Default, proceed as follows:
1.
Delete the power adapter from the socket power of the network camera
2.
With a pin thin enough to go through the Reset Button hole, push inside gently
3.
Plug back the power
4.
The Power LED will flash
5.
Release the pin
6.
The network camera enters into the process of getting back to factory defaults
Or when the device has finished system booting, press the reset button until the Power LED starts flashing.
The device is back to factory default. All settings will be erased from the device, and the assigned IP will be
back to 192.168.1.200 and Subnet mask to 255.255.0.0.
6.2
Viewing the camera from a remote location
The below guideline shows you how to setup the Network Camera for viewing it from a remote location.
The network infrastructure demonstration is just for your reference only. Each network infrastructure may vary
upon the needs of the organization.
Note:
Consult your Network Administrator for a better understanding of networking concepts and related topics.
Reset Button
