Asko TDC33, Руководство по обслуживанию

Страница: 36 / 86

34
SERVICE
3
2,8
9
4
6
5
8
Removing the rear panel
1. Remove the 3 screws at the rear of the top
cover and lift it off.
2. Unscrew the centring nut until the face of the
nut is level with the end of the thread and
knock out the bearing.
3. Fit the special tool (part no. 88 011 54) by
fitting the tube end into one of the stamped
out keyholes in the front rail. Lift the rear edge
of the drum and press the drum edge on to
the roller.
4. Remove the earth connection (yellow/green
wire) from the input terminal block.
5. Take the cable bundle out of the cable clamp
and pull the header block off its terminal pins.
6. Remove the wiring:
Ra, Rb, R13, R14, R34 on the contactor and
F3 and F4 on the radio interference filter.
7. TDC44: Remove the hoses to the water tank
housing.
8. Remove the centring nut and the 8 screws.
9.
TDC44: Remove the 3 plastic screws.
10. Lift off the rear panel.
Installing the rear panel
11. Hook the rear panel on to the base.
12. Remove the special tool.
13. Screw on the centring nut and fit the 8 screws.
14.
TDC44: Refit the hoses.
15. Fit the earth connection and the wiring:
Ra, Rb, R13, R14, R34 on the contactor and
F3 and F4 on the radio interference filter.
16. Push the header block on to its terminal pins
and place the cable bundle in the cable clamp.
17. Fit the top cover.