Asko TDC33, Руководство по обслуживанию

Страница: 16 / 86

14
INSTALLATION
ELECTRICAL INSTALLATION
The electrical installation must be carried out by
a qualified tradesman.
The installation is made using fixed wiring and
a multi-pole breaker.
Connections on delivery
The machine is supplied, depending on market,
for one of the following supplies (see rating
plate):
A. 3-phase, 400V 50Hz supply 10A, heating po-
wer 2620/2500W.
B. Single-phase, 230V 50Hz supply 13/16A, hea-
ting power 2620/2500W.
C. Single-phase, 230V 50Hz supply 10A, hea-
ting power 1900W.
If an earth fault breaker is installed, it should
be of type A.
Rewiring to single-phase
The machine can be reconfigured The machine
should be reconfigured as shown in the wiring
diagram underneath the top panel of the machi-
ne.
IMPORTANT
Electrical connections/rewiring must be carried
out by a qualified tradesman.
IMPORTANT
The electrical rewiring to 1-phase 10A is lengthen
the drying program.
TDC44 (Condenser tumble drier with dis-
play):
For the machine to show the correct remaining
drying time, after rewiring select the Low heating
power (or High if you rewire to 3-phase or
1-phase 16A).
Do this:
Switch off the mains power button, , and
press it again to restart the machine.
Press the
P8
button 5 times, then press the
P2
button 5 times. These 10 button presses must be
done within 15 seconds.
Within 3 seconds of the last button press select
Low with the
P6 P7
buttons.
Joint connection of the tumble drier and an
ASKO washing machine
NOTE
Joint electrical connection as described below
must be carried out by a qualified tradesman.
To ensure even loading of the phases when in-
stalling the tumble drier jointly with a single-phase
ASKO washing machine, the phases should be
connected like this:
Tumble drier:
Terminal labelled L1 to phase 1.
Terminal labelled L2 to phase 2.
Terminal labelled L3 to phase 2.
Washing machine:
Terminal labelled L to phase 3.