Asko TDC33, Руководство по обслуживанию

Страница: 25 / 86

23
COMPONENTS AND MEASUREMENT VALUES
OVERHEATING PROTECTION
Part no.: 80 084 87 (150°C manual)
The 150°C thermostat stops the program if the
temperature rises too high and has to be manual-
ly reset. This thermostat is also called the over-
heating protection.
HUMIDITY SENSOR
Part no.: 80 618 55
The humidity sensor is used to control the dry-
ing process. During operation the sensor output
signal is between 1 and 16 mVDC. Any other
value causes the program to stop.
DOOR SWITCH
Part no.: 50 531 07
The front-loading door operates a door switch,
and when this is open the program stops. If the
door has been opened and closed again during the
program, the machine must be restarted with the
start button.
OVERFILLING PROTECTION TDC44
Part no.: 80 526 43
If both of the tumble drier containers are overfil-
led, the program is halted by a switch located in
the lower container. The display indicates overfil-
ling.
ELECTRICAL CONNECTIONS
The machine is supplied, depending on market,
for one of the following supplies (see rating
plate):
A. 3-phase, 400V 50Hz supply 10A, heating po-
wer 2620/2500W.
B. Single-phase, 230V 50Hz supply 13/16A, hea-
ting power 2620/2500W.
C. Single-phase, 230V 50Hz supply 10A, hea-
ting power 1900W.
The connection cable is 2.0 metres of RKK 5x1.5
mm
2
.
PROGRAM CONTROL TDC44
Program unit
The control unit contains microprocessors to con-
trol the program, motor, heating element etc.
Part no.: 80 639 24
LIQUID CRYSTAL DISPLAY UNIT (Panel board)
The LC display unit include press buttons and
indications.
Part no.: 80 638 75 (ASKO)
Part no.: 80 637 29 (OEM)