ASG, Division of Jergens, Inc.
15700
S. Waterloo Road | Cleveland, OH 44110-3898 | Phone: (888) 486-6163 | Fax: (216) 481-4519 | Email: [email protected] | Web: www.asg-jergens.com
Page 11 of 13
Set Mode (Cont.)
Set Mode
−
Just Move:
Just Move allows the user to measure torque after rotation of a pre-defined number of
degrees. Degrees will count once load applied is above 5% of the maximum tool span.
Torque will be captured at the angle defined here.
Step 1:
Press to scroll to Set Mode
Step 2:
Press to select Set Mode
Step 3:
Press to scroll to select
Just Move
Step 4:
Press to scroll to required pre-set number (i.e. 1 to 99)
Step 5:
Press to confirm pre-set number selected
Step 6:
Press to set just move pre-set angle and to confirm
Pre-Set Mode
In Pre-Set mode, the operator chooses their preferred ‘Pre-Set’ for operation from their
pre-configured pre-sets (using Set Mode). For Torque and Angle Mode wrenches, the
user can choose between Torque, Torque and Angle and Just Move pre-sets.
Step 1:
Press to scroll to Pre-Set Mode
Step 2:
Press to enter Pre-Set Mode
Step 3:
Press to select your preferred pre-set number (i.e. 1 to 99)
Step 4:
Press to operate within this pre-set parameter
Step 5:
Press to store the applied torque if required
Modes of Operation
TAW Series Digital Torque Wrenches
Torque and Angle Model
User Manual
