TD 92483GB
2008-06-05/ Ver. B
Installation and Operation Manual
UPAC- Unite Packet for Messaging and Alarm
44
Changing Monitoring Settings
1
Click “Setup” to set up monitoring parameters.
2
Select input if the input should be changed. Information about changes can be
written in the
Notes
field.
3
Select if the input shall be monitored or not.
When starting to monitor inputs from the UPAC, the status will always be OK
regardless of the actual state of the input. This give that if the input is active when
monitoring is started no Status Log is sent.
4
Enter the name of the equipment.
5
Select logging level from the drop-down list.
Figure 59.
Setting
Description
Input:
The inputs are defined in the I/O setup page. The input can be
changed, for example if the monitored equipment has been
moved.
Monitoring:
If the input should be monitored or not.
Equipment Name:
Is shown as Module in the Status Log.
Level:
The level that the fault shall be reported as.
Persistent:
Fault remains until the input is not active any longer.
Event Description:I Is shown under Description for the Status log.
