TD 92675EN
9 December 2011/ Ver. D
Configuration Manual
Ascom i62 VoWiFi Handset
25
1
In both VoWiFi Handset, press *#34# in idle mode and select “License“ to check that
they have same device type and licenses.
Alternatively, if the spare VoWiFi Handset has been factory reset, press “Info“ and
select “License“.
2
Put the broken VoWiFi Handset in the DP1 cradle.
3
Open the PDM.
4
Make sure that the VoWiFi Handset is saved in the PDM. In the
Numbers
tab, a saved
VoWiFi Handset has the symbol
in the
Saved
column. If not, right-click the VoWiFi
Handset and select “Save“ in order to transfer the settings to the spare VoWiFi
Handset later on.
5
If the spare VoWiFi Handset has been previously used, perform a factory reset, see
5.1.8 Perform a Factory reset
on page 20.
6
Put the spare VoWiFi Handset in the DP1 cradle.
7
A
Found Device Wizard
window appears. Select “Associate with Number“ and click
“Next >“.
8
In the list, select the broken VoWiFi Handset to be replaced with the spare VoWiFi
Handset. Click “OK“.
The broken VoWiFi Handset has been replaced and its settings have been transfered to the
spare VoWiFi Handset.
Replace and Move Licenses using PDM
The broken VoWiFi Handset and the spare VoWiFi Handset do not have the same device
type and/or have the same functionality license.
In order to move the licenses to the spare VoWiFi Handset, it must be an unlicensed Talker.
To check that the VoWiFi Handset is unlicensed, press *#34# in idle mode and select
“License“. Only
i62 Talker
must be displayed here.
1
Put the broken VoWiFi Handset in the DP1 cradle.
2
Open the PDM.
3
Make sure that the broken VoWiFi Handset is saved in the PDM. In the
Numbers
tab, a
saved VoWiFi Handset has the symbol
in the
Saved
column. If not, right-click the
VoWiFi Handset and select “Save“ in order to transfer the settings to the spare
VoWiFi Handset later on.
4
Put an unlicensed spare VoWiFi Handset (Talker) in the DP1 cradle.
5
Run the template with the basic network settings containing (see
4.4 Configure a
Handset with a Template
on page 12):
•
Network settings
1
(located under Network > Network A, B, C, or D)
•
VoIP settings
2
(located under VoIP)
The VoWiFi Handset might be restarted depending on parameter changes.
6
Put the broken VoWiFi Handset in the DP1 cradle.
7
In the PDM, select the “Licenses“ tab.
8
Right-click the broken VoWiFi Handset and select “Move license...“.
9
In the
Move license
window, select the Talker that should receive the license. Press
“OK“. The broken VoWiFi Handset restarts and has now become an Talker.
10
Put the spare VoWiFi Handset in the DP1 cradle.
1.
All required system settings for the WLAN. For example SSID and Security mode.
2.
VoIP protocol, Gatekeeper IP address or SIP Proxy IP adress used to access the PBX.
