TD 92675EN
9 December 2011/ Ver. D
Configuration Manual
Ascom i62 VoWiFi Handset
11
4.2
Installation without Central Device Management (IMS3)
In a small VoWiFi system, the administration can be handled using only the PDM.
The synchronization is in this case not handled automatically by the system when a VoWiFi
Handset’s parameters are changed in the PDM. When the parameters have been changed in
PDM, each VoWiFi Handset must be placed in the DP1 cradle connected to the
administrator’s computer in order to synchronize the parameters with the VoWiFi Handset.
1
Open the PDM.
2
In the
Numbers
tab, click “New“. The
New numbers
window is opened.
3
In the
Device Type
and
Parameter version
drop-down lists, select the matching
device type and the parameter version for the VoWiFi Handset to be use, respectively.
4
In the
Prefix
field, enter the numbers’ prefix (if needed).
5
Create a range of numbers by selecting the “Range“ option. Enter the start call
number and the end call number in the fields, respectively.
6
Click “OK”.
7
Create a network settings template (see
4.4.1 Create a template
on page 12) with
the following network parameters:
•
Network settings
1
(located under Network > Network A, B, C, or D)
8
Create another template (see
4.4.1 Create a template
on page 12) with the common
VoWiFi Handset settings applicable to all VoWiFi Handsets (exclude the network
parameters and used security settings). Example of parameters settings:
•
VoIP settings
2
(located under VoIP)
•
Software TFTP IP address (if any) (located under Device > General)
•
Syslog settings
3
(if any) (located under Device > General)
In addition, settings for hiding menu items in the display, certain level of ring signal
and vibrators etc can also be configured.
9
Apply the network settings template to the VoWiFi Handset, see
4.4.2 Apply a
Template to a Handset with a Number
on page 13.
10
Apply the common settings template to the VoWiFi Handset, see
4.4.2 Apply a
Template to a Handset with a Number
on page 13.
11
Put the VoWiFi Handset in the DP1 cradle.
12
In the
Device Wizard
window, select “Associate with number“ and press “OK“.
13
Select the VoWiFi Handset to associate with. Press “OK“.
The number and parameter settings saved in the PDM will now be synchronized with the
VoWiFi Handset. In addition, the VoWiFi Handset’s Device ID will also be synchronized with
the number in the PDM.
If certificates must be used to access a VoWiFi system, also perform the steps 14 - 19.
14
In the
Numbers
tab, right-click the VoWiFi Handset’s number and select “Edit
certificates“. An
Edit certificate
window opens.
15
In the
Root
tab and
Client
tab, click “Edit“ and select the certificates to import. Click
“Close“.
16
In the
Numbers
tab, right-click the VoWiFi Handset’s number and select “Edit
parameters“.
1.
All required system settings for the WLAN. For example SSID and Security mode.
2.
VoIP protocol, Gatekeeper IP address or SIP proxy IP address used to access the PBX.
3.
The parameter “Syslog“ must be enabled in order to set the “Syslog IP address“.
