ASAHI PENTAX S3, Руководство по обслуживанию

Страница: 6 / 54

NOTE: Never touch the surface of the mirror with a fingertip or any kind of tool. If the mirror gets
dusty, use a soft brush or a blower to dust it off.
3. Disassembly of Top Transport Mechanism.
a. WIND-UP LEVER SEAT (C35)
Press the edge of the spring (Cl9) with finger to prevent it from recoiling, and then take out (C35) from
the wind-up lever shaft (C34), after which if (C19) is properly fixed to (C 35), using shape wire, the
trouble of recoiling the spring can be dispensed with at time of reassembling.
(Diagram 1)
NOTE: When recoiling (C19), do it with gloves on. If handled with bare fingers, the spring trends to be
rusted.
(Diagram 1)
b. LEVER STOPPER (Cl0)
Take out 2 screws (15) and 2 stopper washers (C68).
c. TOP FIRST GEAR (C20)
Prior to taking out the top 1st gear (C20), mark the body proper (A01) with a dot, indicating the spot
extended from the corner of either one of the two projected points and an accurate angle can be easily
determined when reassembling.
(Diagram 2)
(Diagram 2)
Mark here with a dot
d. WIND-UP LEVER SHAFT (C34) Unloose 3 screws (17).
4. Disassembly of Bottom Transport Mechanism.
a. BOUNCE STOPPER ACTUATOR LEVER (E08)
Remove the bounce stopper lever screw (E103) and ease the bounce stopper actuator lever screw (E100)
and take out; he bounce stopper lever (E99) and bounce stopper spring (E102) with particular attention to
the washer W3—located beneath (E98).
NOTE: When (E98) is removed, (E99) must also be taken out, because once (E98) is dismantled, (E99)
is invariably placed in a position where the bounce stopper mechanism is at work, and if, by any
chance, the shutter is cocked, the 1st curtain will thereby very likely be damaged.
b. COUPLER LEVER (C15)
Remove the coupler lever retainer screw (C80).
230-2 -6
-