ASAHI PENTAX S3, Руководство по обслуживанию

Страница: 15 / 54

In the event a wide gap has been created on either parts, lift the top 1st gear (C20) and change its
engaging position with that of (C21). In the event any one of the gears on the upper part of the body
proper has been replaced, proper adjustment of the aforementioned gap may sometimes be found
impossible. In such a case as this where a delicate adjustment is called for, 5 kinds of the lever seat lug
(C05), each different in length, are available.
Diagram 14 C05-1 C05-2 C05-3 C05-
4
C05-5
The Longest The
Shortest
NOTE: If (C10) and/or (C35) are filed off for the purpose of adjusting the gap, the rotating angle of
(C03) changes, in consequence of which it sometimes becomes extremely difficult or impossible
to adjust the counter assembly which is to be fixed on it.
Photo6
e. BOUNCE STOPPER MECHANISM
(1) When fixing the pin adjust plate (C17) to the bottom main gear (C24), determine the position of the
coupler lever pin (C51) and fasten the screws (14) and (23). ((Refer to Diagram 13.)
(2) The relative position of the bounce stopper lever (E99) to the sync gear (E104) is to be adjusted as
per Diagram 16. Upon completion of the adjustment, cock the shutter to ensure that the bounce
stopper (E97) will rotate smoothly without hooking up the bounce stopper lever (E99) at the initial
stage of cocking.
Diagram 16
Photo 7
230-2 -15
-