ASAHI PENTAX S3, Руководство по обслуживанию

Страница: 12 / 54

Diagram 8
Location must be adjusted the tolerance of
0.5mm
b. STOPPER (C11)
After installing the 1st curtain checker arm (E07) and the stopper (C11), the gap between the projected
point of the selector gear stopper (E77) and (C11) should be adjusted to be 0.2-0.3 mm in the cocked
condition. This adjustment should be made by turning the screw (22) which is screwed in through the
back of (A01). (Diagram 9)
Diagram 9
Photo 3
c. IDLING GEAR PARTS
NOTE: Read carefully the following instructions and utmost caution should be exercised when adjusting
this part which is delicate in nature.
When installing the winding shaft parts, spill spring (E58), spill rest (E21), bottom idling gear (E16)
and spill (E08), slowly rotate clock-wise the top main gear retainer screw (C75) first with a driver,
while pressing downward (EOS) with the tip of tweezers. When the spill (E08) comes above the
groove of the idling gear shaft (E20), it falls into the groove, pushed against the direction of the
rotation of the various gears, preventing them from rotating. (Diagram 10)
-
Diagram 10
230-2 -12