ECOsaver V240SP
22
On
Tank full lamp
On
Tank full lamp
① Make sure the power plug
and the power cord have no
damage.
② Connect the Safety cable
to the float sensor on the
cylinder.
③ Set the Auto stop/run switch
to the “Run” position.
④ Set the Power switch to the
“ON” position.
⑤ Push the Start switch.
⑥ Make sure the recovery
machine starts.
⑦ Make sure the Tank full
lamp is on and the recovery
machine stops when the
Safety cable is disconnected.
MAINTENANCE & INSPECTION
Check the cords
● Inspect and clean regularly as instructed below and perform correction or replacement timely.
① Connect the Safety cable
to the float sensor on the
cylinder.
② Set the Auto stop/run switch
to the “Run” position.
③ Set the Power switch to the
“ON” position.
④ Push the Start switch.
⑤ Make sure the recovery
machine starts.
⑥ Make sure the Tank full
lamp is on and the recovery
machine stops when the
cylinder is turned upside
down.
Check the overfilling prevention function (in case a cylinder with float sensor is used)
① Connect the Safety cable to
the connector on the Limit
Scale.
② Set the Auto stop/run switch
to the “Run” position.
③ Set the Power switch to the
“ON” position.
④ Push the Start switch.
⑤ Make sure the Tank full
lamp is on and the recovery
machine stops when the
cylinder is pushed by hand
to give the weight which
is enough to operate the
overfilling function.
Check the overfilling prevention function (in case a cylinder without float sensor is used)
① Remove the strainer holder
on the suction port by using
a wrench.
② Check the strainer and clean
it with water or thinner if
clogged or dirty.
③ Dry it well before installing.
＊ If damaged, replace it with a
new one.
Cleaning・replacement of the built-in strainer
① Make sure there is no leak from the machine, the hoses and so on.
Check refrigerant leak
Clean
Strainer
On
Tank full lamp
MAINTENANCE &
INSPECTION
